MDT Picatinny Rails for the MDT Accessory Scope Ring Caps

Ideal for mounting bubble levels, data card holders, laser range finders and more.

Available in two sizes, 1″ inch and 5″ inch

Made in Canada

You will need the “MDT Accessory Scope Ring Caps for Elite and Unimount” (sold separately) to use these mounting plates

Note: This listing is for the rail only.  Rings/mounts, accessories and accessory scope cap in photos not included

SPECIFICATIONS

1″ Picatinny Rail

• 1″ overall length
• Adheres to STANAG 4694 picatinny rail profile (NATO rail configuration)
• 1 cross slot
• 2x #6-48 x 1/4″ mounting screws
• Integral recoil lug and offset mounting holes to prevent attached accessories from shifting under recoil
• Ideal for mounting bubble levels, data card holders and red dot sights (RDS) with picatinny interface

5″ Picatinny Rail

• 4.7″ overall length with 2.86″ of available mounting surface
• 1″ tall (above top of ring cap)
• Cut to clear most common 56 mm objective diameter (and below) scopes
• Adheres to STANAG 4694 picatinny rail profile (NATO rail configuration)
• 7 cross slots
• 2x #6-48 x 1/4″ mounting screws
• Integral recoil lug and offset mounting holes to prevent attached accessories from shifting under recoil
• Ideal for mounting laser range finders and IR illuminators
• Can also be used as a “top hand rest” when shooting in position

ATP is an authorised Australian dealer for MDT. All MDT products bought from ATP are covered by the Australian MDT Warranty.