Picatinny cross slots run the full length of the rail, which gives the shooter flexibility when mounting scope rings and other accessories. The channel in the center reduces the overall mass of the mount, weighing in at 2-3oz on average. Also, in many cases, it will not obstruct usage of factory iron sights. EGW’s one piece scope mounts are the obvious choice for hunters and tactical shooters alike.
- This mount is available with a 0 MOA slope
- Mounting screws and allen wrench included
- This mount is a Picatinny-style base and compatible with Picatinny or Weaver scope rings.
- Made in the USA
- 6061 T6 Aircraft Grade Aluminium
- Black models are Type 2 Anodized
Installation: EGW recommends 20 inch lbs of torque and a drop of blue loctite
SMITH & WESSON RAILS: The bolt pattern on this mount fits factory drilled Smith & Wesson revolvers. To suit K, L, N and X Frame Revolvers. Swing the cylinder out on your gun and look under the top strap. If you see the holes under the sight, through the top strap, your gun is factory drilled and tapped. Our mount fits snugly into the rear sight cut and has a recoil shoulder, unlike some mounts that are simply radiused to fit the top radius and do not go into the rear sight cut.
RUGER RAILS: This mount fits: Ruger Blackhawk, Ruger Redhawk, GP100 (with adjustable rear sights), GP100 Match Champion only. This rail mounts using the hole from your rear sight, but also requires you to drill and tap two additional holes in your receiver if your gun is not already drilled and tapped.
Available for the following:
#49000: Ruger Blackhawk, Redhawk, GP100 (with adj. rear sights), GP100 Match Champion. – 0 MOA – Black
#49004: Ruger Blackhawk, Redhawk, GP100 (with adj. rear sights), GP100 Match Champion. – 0 MOA – Silver
#49100: Smith & Wesson K, L, N and X Frame Revolvers – 0 MOA – Black
#49104: Smith & Wesson K, L, N and X Frame Revolvers – 0 MOA – Silver
ATP is an authorised Australian dealer for EGW. All EGW products bought from ATP are covered by EGW’s Australian Warranty.