EGW HD Heavy Duty Tactical Picatinny Scope Rings Serialised and Matched

EGW’s bestselling rings are created in American-made Fadal machines by machining aircraft grade aluminum from billet one pair of rings at a time. 

We bore the holes to 30mm +.0014”. When we machine the profiles of the ring we build in a .030” radius on all outside edges. Next we machine a 45 degree bevel around the entire ring and clamp. We clamp the pair on a 30mm mandrill with a 1/8” pin to keep the pair exactly together. We then thread form and tap holes in the ring. Thread forming is 40% stronger than cut threads. 

The rings are serial engraved before they are separated. One ring and cap has a decimal in front of the numbers so the caps match exactly. i.e. one ring will show “575” and its identical twin will show “.575”. 

We then sand blast them for a matte finish and anodize them in Eastern Pennsylvania, USA.

The cross bolt is made from chromoly steel in our turning centers, roll threaded in-house and heat treated and blued locally. The ring nut is beveled on both ends and an inset washer is used to keep the nut from scoring the finish on the clamp. The threads are roll formed for strength, fit (class 2a) and finish. The clamp is machined from billet and complete with radius and bevels, and anodized to the match rings. 

We recommend that you torque the crossbolts of our HD Rings to 65 inch pounds, and the top screws to 15 inch pounds.

Each pack contains a pair of 2 rings.

Heights are measured from the centre of the scope tube to the top of the picatinny rail.

Only available to fit 30mm scope tubes, however ring inserts (made of delrin) are available (sold separately) which will allow you to use scopes with 1″ inch tubes.

Height are Low (0.850″, Medium (0.990″), High (1.275″)

Available in:

#61100 Low Height 0.850″

#61101 Medium Height 0.990″

#61102 High Height 1.275″

#60106 1″ Delrin inserts, pair

ATP is an authorised Australian dealer for EGW. All EGW products bought from ATP are covered by EGW’s Australian Warranty.